Linux version 3.1.4 (tj@hephaestion.lan.iam.tj) (gcc version 4.9.3 (Ubuntu 4.9.3-5ubuntu1) ) #21 Wed Nov 25 09:55:17 GMT 2015
BIOS-provided physical RAM map:
 BIOS-e820: 0000000000000000 - 000000000009fc00 (usable)
 BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved)
 BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved)
 BIOS-e820: 0000000000100000 - 000000001ffe0000 (usable)
 BIOS-e820: 000000001ffe0000 - 0000000020000000 (reserved)
 BIOS-e820: 00000000fffc0000 - 0000000100000000 (reserved)
Notice: NX (Execute Disable) protection missing in CPU!
DMI 2.8 present.
last_pfn = 0x1ffe0 max_arch_pfn = 0x100000
init_memory_mapping: 0000000000000000-000000001ffe0000
0MB HIGHMEM available.
511MB LOWMEM available.
  mapped low ram: 0 - 1ffe0000
  low ram: 0 - 1ffe0000
Zone PFN ranges:
  DMA      0x00000010 -> 0x00001000
  Normal   0x00001000 -> 0x0001ffe0
  HighMem  empty
Movable zone start PFN for each node
early_node_map[2] active PFN ranges
    0: 0x00000010 -> 0x0000009f
    0: 0x00000100 -> 0x0001ffe0
Allocating PCI resources starting at 20000000 (gap: 20000000:dffc0000)
Built 1 zonelists in Zone order, mobility grouping on.  Total pages: 129903
Kernel command line: console=ttyS0,115200n8
PID hash table entries: 2048 (order: 1, 8192 bytes)
Dentry cache hash table entries: 65536 (order: 6, 262144 bytes)
Inode-cache hash table entries: 32768 (order: 5, 131072 bytes)
Initializing CPU#0
Initializing HighMem for node 0 (00000000:00000000)
Memory: 516532k/524160k available (1225k kernel code, 7176k reserved, 546k data, 464k init, 0k highmem)
virtual kernel memory layout:
    fixmap  : 0xfffe4000 - 0xfffff000   ( 108 kB)
    pkmap   : 0xff800000 - 0xffc00000   (4096 kB)
    vmalloc : 0xe07e0000 - 0xff7fe000   ( 496 MB)
    lowmem  : 0xc0000000 - 0xdffe0000   ( 511 MB)
      .init : 0xc11bc000 - 0xc1230000   ( 464 kB)
      .data : 0xc11326e4 - 0xc11bb200   ( 546 kB)
      .text : 0xc1000000 - 0xc11326e4   (1225 kB)
Checking if this processor honours the WP bit even in supervisor mode...Ok.
SLUB: Genslabs=15, HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
NR_IRQS:16 nr_irqs:16 16
Console: colour VGA+ 80x25
console [ttyS0] enabled
Calibrating delay loop... 441.98 BogoMIPS (lpj=220992)
pid_max: default: 32768 minimum: 301
Mount-cache hash table entries: 512
CPU: Intel 486 DX/4 stepping 00
Checking 'hlt' instruction... OK.
Checking for popad bug... OK.
Performance Events: no PMU driver, software events only.
PCI: PCI BIOS revision 2.10 entry at 0xfd40f, last bus=0
PCI: Using configuration type 1 for base access
bio: create slab <bio-0> at 0
vgaarb: loaded
SCSI subsystem initialized
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
PCI: Probing PCI hardware
pci 0000:00:01.3: quirk: [io  0x0600-0x063f] claimed by PIIX4 ACPI
pci 0000:00:01.3: quirk: [io  0x0700-0x070f] claimed by PIIX4 SMB
vgaarb: device added: PCI:0000:00:02.0,decodes=io+mem,owns=io+mem,locks=none
pci 0000:00:01.0: PIIX/ICH IRQ router [8086:7000]
Switching to clocksource pit
pci 0000:00:00.0: Limiting direct PCI/PCI transfers
pci 0000:00:01.0: PIIX3: Enabling Passive Release
pci 0000:00:01.0: Activating ISA DMA hang workarounds
platform rtc_cmos: registered platform RTC device (no PNP device found)
HugeTLB registered 4 MB page size, pre-allocated 0 pages
io scheduler noop registered
io scheduler deadline registered
io scheduler cfq registered (default)
Serial: 8250/16550 driver, 4 ports, IRQ sharing enabled
˙serial8250: ttyS0 at I/O 0x3f8 (irq = 4) is a 16550A
Non-volatile memory driver v1.3
ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver
ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver
uhci_hcd: USB Universal Host Controller Interface driver
Initializing USB Mass Storage driver...
usbcore: registered new interface driver usb-storage
USB Mass Storage support registered.
serio: i8042 KBD port at 0x60,0x64 irq 1
serio: i8042 AUX port at 0x60,0x64 irq 12
mousedev: PS/2 mouse device common for all mice
input: AT Translated Set 2 keyboard as /devices/platform/i8042/serio0/input/input0
usbcore: registered new interface driver usbhid
usbhid: USB HID core driver
Freeing unused kernel memory: 464k freed
Kernel panic - not syncing: Attempted to kill init!
Pid: 1, comm: init Not tainted 3.1.4 #21
Call Trace:
 [<c112f72e>] ? panic+0x4d/0x127
 [<c101969f>] ? do_exit+0x5b/0x505
 [<c1019b96>] ? do_group_exit+0x2b/0x5d
 [<c1020cf4>] ? get_signal_to_deliver+0x373/0x383
 [<c1002842>] ? do_bounds+0x4b/0x4b
 [<c1001ba2>] ? do_signal+0x2c/0x769
 [<c1020364>] ? force_sig_info+0x77/0x7f
 [<c1002842>] ? do_bounds+0x4b/0x4b
 [<c100ff4e>] ? do_page_fault+0x2b3/0x357
 [<c100ff4e>] ? do_page_fault+0x2b3/0x357
 [<c10060a7>] ? sys_execve+0x4b/0x53
 [<c10060a7>] ? sys_execve+0x4b/0x53
 [<c1131cf2>] ? ptregs_execve+0x12/0x18
 [<c1131896>] ? work_notifysig+0x13/0x19
 [<c1002842>] ? do_bounds+0x4b/0x4b
 [<c10024ad>] ? do_notify_resume+0xd/0x2a
 [<c1131896>] ? work_notifysig+0x13/0x19
 [<c1002842>] ? do_bounds+0x4b/0x4b